Degreeing in the camshaft – Part II – Phasing the camshaft

Part I of this article went into detail as how to find exact TDC. With that now behind us, the actual process of checking the camshaft and how it is currently phased within the engine can begin. For this, a 1.000” travel dial indicator will be required that can measure the up and down motion of the lifters. While the number one cylinder is customarily the cylinder of choice in which to check the camshaft, any cylinder can be used to degree in the camshaft once TDC has been found for that cylinder. In fact, later in this operation another cylinder will be checked in which to both verify the results obtained off of the first cylinder check and also insure that the camshaft is at least consistent in values on two different cylinders. For now, the number one cylinder will be used as a reference.

Continue reading “Degreeing in the camshaft – Part II – Phasing the camshaft”